Subject: Problem raith SNF 2007-04-05 17:03:29: qualification failed for stitching and out of plane focus
Date: Thu, 5 Apr 2007 17:03:30 -0700

QUALIFICATION FAILED. It failed for the same issues as before in the last 7 runs:
large offset in the spot offset calibration results in errors during the WF aligment
which then results in WF:WF stitching errors.
Stage on Piezo is out of level planarity resulting in poor focus as you expose across
a wafer.
Possible exposure error:
Unknow reason for a ~7.5 U and ~15 V shift in UV coordinate system for entire PLS written.
May have been a error in setting up UV system on write job. checked PLS and protocol
log file and it has the correct positions in the PLS and LOGS.
Try again next week after repairs to piezo post heights.
Users are not to exceed 10 keV acceleration voltage.  Users should call me if they have
questions or observe anything unusual.