From khanh at snf.stanford.edu Wed Feb 13 10:56:42 2002 From: khanh at snf.stanford.edu (khanh at snf.stanford.edu) Date: Feb 13, 2002 10:56:42 AM Subject: Problem AG4108 2002-02-13 10:56:40: RTA failure Message-ID: Message # 79: Lamp failure, top center bank From khanh at snf.stanford.edu Wed Feb 13 11:37:06 2002 From: khanh at snf.stanford.edu (khanh at snf.stanford.edu) Date: Feb 13, 2002 11:37:06 AM Subject: Shutdown AG4108 2002-02-13 11:37:04: Lampoly failure Message-ID: From booth at snf.stanford.edu Wed Feb 20 02:58:59 2002 From: booth at snf.stanford.edu (booth at snf.stanford.edu) Date: Feb 20, 2002 2:58:59 PM Subject: Shutdown AG4108 2002-02-13 11:37:04: Lamp failure Message-ID: NV-RAM problem. Must reset Config 1 & 2 when system has been rebooted. Software to repair NV-RAM config. is on order. From booth at snf.stanford.edu Wed Feb 20 02:59:10 2002 From: booth at snf.stanford.edu (booth at snf.stanford.edu) Date: Feb 20, 2002 2:59:10 PM Subject: Problem AG4108 2002-02-13 10:56:40: RTA failure Message-ID: From booth at snf.stanford.edu Wed Feb 20 03:00:14 2002 From: booth at snf.stanford.edu (booth at snf.stanford.edu) Date: Feb 20, 2002 3:00:14 PM Subject: Problem AG4108 2002-02-20 15:00:12: Config 1&2 values must be checked Message-ID: From khanh at snf.stanford.edu Thu Feb 21 10:26:15 2002 From: khanh at snf.stanford.edu (khanh at snf.stanford.edu) Date: Feb 21, 2002 10:26:15 AM Subject: Problem AG4108 2002-02-21 10:26:14: lamp failure, top center bank on RTA Message-ID: From khanh at snf.stanford.edu Thu Feb 21 10:26:40 2002 From: khanh at snf.stanford.edu (khanh at snf.stanford.edu) Date: Feb 21, 2002 10:26:40 AM Subject: Shutdown AG4108 2002-02-21 10:26:38: Lamp failure Message-ID: From booth at snf.stanford.edu Thu Feb 21 11:56:40 2002 From: booth at snf.stanford.edu (booth at snf.stanford.edu) Date: Feb 21, 2002 11:56:40 AM Subject: Shutdown AG4108 2002-02-21 10:26:38: Lamp failure Message-ID: Checked bulb resistance & fuse continuity - OK. Checked toroid wiring & position - OK. Did Lamp Calibration test - all values from EEPROM were zero! EE-PROM had lost all prior test values, so Lamp Test routine was always going to fail. Did new Lamp Cal. test & saved new test values to EE-PROM. Now Lamp Test completes successrully. From booth at snf.stanford.edu Thu Feb 21 11:56:53 2002 From: booth at snf.stanford.edu (booth at snf.stanford.edu) Date: Feb 21, 2002 11:56:53 AM Subject: Problem AG4108 2002-02-21 10:26:14: lamp failure, top center bank on RTA Message-ID: From hlkung at snf.stanford.edu Thu Feb 21 03:52:49 2002 From: hlkung at snf.stanford.edu (hlkung at snf.stanford.edu) Date: Feb 21, 2002 3:52:49 PM Subject: Problem AG4108 2002-02-21 15:52:47: argon flow low. Recipes with argon do not run Message-ID: