From chienyuc at snf.stanford.edu Thu Jun 9 10:33:00 2011 From: chienyuc at snf.stanford.edu (chienyuc at snf.stanford.edu) Date: Thu, 9 Jun 2011 10:33:00 -0700 Subject: Problem bluem SNF 2011-06-09 10:32:59: oven not able to heat up Message-ID: Ran program 3 but found the temperature was not able to go beyond 50C (set point 200C in the first step). Checked program and stop/re-run it but still the same. From gsosa at snf.stanford.edu Thu Jun 9 15:23:51 2011 From: gsosa at snf.stanford.edu (gsosa at snf.stanford.edu) Date: Thu, 9 Jun 2011 15:23:51 -0700 Subject: Shutdown bluem SNF 2011-06-09 15:23:51: Temp control problem Message-ID: Oven not heating up properly. Needs further troubleshooting. From gsosa at snf.stanford.edu Fri Jun 10 15:44:04 2011 From: gsosa at snf.stanford.edu (gsosa at snf.stanford.edu) Date: Fri, 10 Jun 2011 15:44:04 -0700 Subject: Comment bluem SNF 2011-06-10 15:44:03: Update 6/10 Message-ID: Was able to replace the controller and set the proper configuration for output functions. Controller looks like it is functioning normallly. Still need to do a tuning procedure, a profile and transer the programs before releasing the oven From gsosa at snf.stanford.edu Mon Jun 13 15:44:56 2011 From: gsosa at snf.stanford.edu (gsosa at snf.stanford.edu) Date: Mon, 13 Jun 2011 15:44:56 -0700 Subject: Problem bluem SNF 2011-06-09 10:32:59: oven not able to heat up Message-ID: Troubleshot and replaced temperature controller. Entered in all controller configuration data and locked out access to critical parameters. Transfered all programs from old controller to new controller. Checked oven temperature calibration at 80 and 150 degrees C.- All OK. Ran a test program up to 425 Degrees C.- All OK. System ready for use. Please verify your program before running the oven. Also ensure that Event E1 is set to "Off" and Event E2 is set to "On" for proper oven operation and heating function. From gsosa at snf.stanford.edu Mon Jun 13 15:45:01 2011 From: gsosa at snf.stanford.edu (gsosa at snf.stanford.edu) Date: Mon, 13 Jun 2011 15:45:01 -0700 Subject: Shutdown bluem SNF 2011-06-09 15:23:51: Temp control problem Message-ID: Troubleshot and replaced temperature controller. Entered in all controller configuration data and locked out access to critical parameters. Transfered all programs from old controller to new controller. Checked oven temperature calibration at 80 and 150 degrees C.- All OK. Ran a test program up to 425 Degrees C.- All OK. System ready for use. Please verify your program before running the oven. Also ensure that Event E1 is set to "Off" and Event E2 is set to "On" for proper oven operation and heating function.