[Fwd: Microscope computer configuration settings]

[Mike Bell]

These are the settings that need to done on the CNRI computer.

The root logon can be obtained from Andrew.


-------- Original Message --------
Subject: Microscope computer configuration settings
Date: Fri, 08 Feb 2002 15:11:56 -0500
From: Andrew Kuchling <akuchlin at mems-exchange.org>
Reply-To: akuchlin at mems-exchange.org
To: mbell at snf.stanford.edu

For /etc/network/interfaces:

IP address: 171.64.100.40
netmask: 255.255.255.0
gateway: 171.64.100.1

(And then run 'ifdown eth0; ifup eth0'.)

For /etc/resolv.conf:

domain stanford.edu
nameserver 171.64.7.55
nameserver 171.64.7.77
nameserver 171.64.7.99

That should be enough to get the machine on the network so that I can
log in remotely.  At that point I can change the hostname from
cnf-scope to snf-scope, test the configuration of the microscope, and
do any other configuration changes which are required.

Thanks!

	Regards,

-- 
A.M. Kuchling			  akuchlin at mems-exchange.org
Technical Staff, MEMS Exchange    Tel.: (703) 262-5368 x5374