From tkato at snf.stanford.edu Wed Aug 27 12:23:43 2003 From: tkato at snf.stanford.edu (tkato at snf.stanford.edu) Date: Aug 27, 2003 12:23:43 PM Subject: Problem cpd 2003-08-27 12:23:42: Report Problem for cpd Message-ID: there were 2 problems. 1) All LEDs were blinking at the HEAT step. I reported to Uli, and then I turned off the Chanber Power, and switched to Bottle B. I was using BottleA. initial=141 lb, after this run, 138.5 lb. (bottole A need to be replaced.) 2)following 1st run, I run again. this time, temperature at Fill, PURGE and POST PURGE FILL wasn't 10 decC. It increased from 10 C to about 19 C during these steps. Pressure was beyond 1075psi at HEAT step, but there was all LEDs blinking for a while between HEAT and blinking HEAT step. From maurice at snf.stanford.edu Wed Aug 27 06:09:20 2003 From: maurice at snf.stanford.edu (maurice at snf.stanford.edu) Date: Aug 27, 2003 6:09:20 PM Subject: Problem cpd 2003-08-27 12:23:42: Report Clear for cpd Message-ID: Test run okay From tkato at snf.stanford.edu Fri Aug 29 04:12:09 2003 From: tkato at snf.stanford.edu (tkato at snf.stanford.edu) Date: Aug 29, 2003 4:12:09 PM Subject: Shutdown cpd 2003-08-29 16:12:09: Report Shutdown for cpd Message-ID: all LEDs were blinking again turned off chamber power, and then vent the chamber. both of bottle LCO2 look empty. (bottle B is 139.5 lb.)