From ahazeghi at stanford.edu Sat Apr 5 15:39:44 2008 From: ahazeghi at stanford.edu (Arash Hazeghi) Date: Sat, 5 Apr 2008 15:39:44 -0700 Subject: Cryostation policy reminder Message-ID: <002e01c8976d$f22ddae0$d68990a0$@edu> Hi all, I found the transfer line hooked up to the system, looks like transfer line was hooked up to the system for a few days and system was unattended. I also noticed some of the accessories including a couple of wrenches and a vacuum grease pack were missing. Please note that you MUST disconnect the transfer line from the system after you are done with your experiment, you also have to take your sample out unless the tool is enabled under your name and you are doing experiments. In future all samples left in the system without measurement in progress will be discarded, meaning that I will assume they are trash and toss them. This is a community tool so please be considerate, after doing your measurement clean up the area and put all the tools back in their original containers, this way we can keep the tool up and running and useful to everyone. Also don't forget to fill the log sheet for probe tips in addition to usage log sheet , if you forget to remember the log sheet you are responsible to replace ALL the broken tips even if you did not break them. Thank you, Arash ---------------------------------------------------------------------------- ------ Arash Hazeghi PhD Candidate Stanford Center for Integrated Systems CIS-X 300, 420 Via Palou Mall, Stanford, CA 94305 phone: +1-650-725-0418 web: http://www.stanford.edu/~ahazeghi -------------- next part -------------- An HTML attachment was scrubbed... URL: From ahazeghi at stanford.edu Fri Apr 11 16:11:10 2008 From: ahazeghi at stanford.edu (Arash Hazeghi) Date: Fri, 11 Apr 2008 16:11:10 -0700 Subject: Triax cables Message-ID: <20080411161110.z1qok851wsscscww@webmail.stanford.edu> Greetings cryostation users, I just wanted to remind you that the yellow cables need be attached to traix feedthorughs on system probes at all times. Under no circumstances should you unplug, modify or use different cables or adapters. the triax feedthroughs on the arms are proprietary ports and using any connector other than the yellow cables will cause leakage through the feedthroughs. Thank you, Arash