From tberg at stanford.edu  Fri Nov  2 13:47:16 2012
From: tberg at stanford.edu (Ted Berg)
Date: Fri, 02 Nov 2012 13:47:16 -0700
Subject: Do NOT disable after running
Message-ID: <50943154.8090104@stanford.edu>

Apparently not everyone got this message>I have enabled in community 
service and the tool is available.

Hello All,
as we said we have a work around for the H2 problem . The Tool will stay 
in cold idle as long as it is enabled. so John has created a community 
service account that allows us to keep it up and not charge the users.In 
order to keep track there is a manual sheet that shows if you are using 
it or not. You must enable in your normal account when running and 
enable over yourself with community service when finished. DO NOT
  DISABLE



From tberg at stanford.edu  Mon Nov  5 13:42:37 2012
From: tberg at stanford.edu (Ted Berg)
Date: Mon, 05 Nov 2012 13:42:37 -0800
Subject: Looks like creep is fixed
Message-ID: <509832CD.8090303@stanford.edu>

Replaced H2 stick leak checked watched regulator did not see creep in 10 
minutes. Ran 2 Geetch coats with no problems. It is OK to operate in 
normal mode now. Happy processing. Ted


From tberg at stanford.edu  Mon Nov 12 12:34:25 2012
From: tberg at stanford.edu (Ted Berg)
Date: Mon, 12 Nov 2012 12:34:25 -0800
Subject: GeH4 is very low. Do not run critical runs
Message-ID: <50A15D51.7030007@stanford.edu>

GeH4 is very low. Do not run critical runs. Cylinder should be here 
later this week.


From tberg at stanford.edu  Fri Nov 30 13:30:20 2012
From: tberg at stanford.edu (Ted Berg)
Date: Fri, 30 Nov 2012 13:30:20 -0800
Subject: Major PM to begin on Monday
Message-ID: <50B9256C.4090009@stanford.edu>

Hello All,
     Parts have been ordered for completion of a major PM on Epi. The PM 
will begin on Monday and may last several days. The domes which have 
been coated and are not coming clean will be replaced as well as lamps 
and suceptor and process kit. trying to make life better. Ted