From mtang at snf.stanford.edu Wed Sep 2 12:49:16 2009 From: mtang at snf.stanford.edu (mtang at snf.stanford.edu) Date: Wed, 2 Sep 2009 12:49:16 -0700 Subject: Problem evalign SNF 2009-09-02 12:49:16: mask vacuum failed Message-ID: From mtang at snf.stanford.edu Wed Sep 2 12:52:01 2009 From: mtang at snf.stanford.edu (mtang at snf.stanford.edu) Date: Wed, 2 Sep 2009 12:52:01 -0700 Subject: Problem evalign SNF 2009-09-02 12:49:16: mask vacuum failed Message-ID: With help from Gary, removed the mask holder and found some gooey stuff on the underside (cleaned off with acetone) and one of the orings under the mask holder had gone missing. Gary & Mario found a new oring and mask vacuum works fine now. Will check with previous user. From vilanova at snf.stanford.edu Wed Sep 9 07:26:19 2009 From: vilanova at snf.stanford.edu (vilanova at snf.stanford.edu) Date: Wed, 9 Sep 2009 07:26:19 -0700 Subject: Shutdown evalign SNF 2009-09-09 07:26:19: Monthly Lamp Change & calibration In progress... Message-ID: Monthly Lamp Change & calibration In progress... From vilanova at snf.stanford.edu Wed Sep 9 08:21:17 2009 From: vilanova at snf.stanford.edu (vilanova at snf.stanford.edu) Date: Wed, 9 Sep 2009 08:21:17 -0700 Subject: Shutdown evalign SNF 2009-09-09 07:26:19: Monthly Lamp Change & calibration In progress... Message-ID: Monthly Lamp Change and calibration Completed. Intensity = 10.14 Mw/Cm2 Uniformity = 1.67% From vilanova at snf.stanford.edu Thu Sep 10 08:14:47 2009 From: vilanova at snf.stanford.edu (vilanova at snf.stanford.edu) Date: Thu, 10 Sep 2009 08:14:47 -0700 Subject: Comment evalign SNF 2009-08-26 10:54:04: lots of slop in Y micrometer Message-ID: The Y MIcrometer was missing an small part that goes on the end of the tip I replaced it with a new On and I also Lubricated the MIcrometer Because it was a little hard to turn, Tested Good to use. :-)