Problem fiji2 SNF 2012-05-22 17:58:59: various issues

jprovine at snf.stanford.edu jprovine at snf.stanford.edu
Wed May 23 00:17:35 PDT 2012


1. MFC 2 reads at 15 sccm even when set to 0.
not anymore...not found in this state.
2. Mechanical sample loading becoming increasing difficult.
will need to take down machine in the future for transfer arm repair.  holding on this until necessary
3. Flaking on chuck
did you clean the chuck?  i did.
4. When loading sample, need to do a pump w/o turbo first then transfer sample.
good point.  this has been the case intermittantly since the repairs last friday.  not sure of the reason behind this, but for now the solution is as you mentioned.




More information about the fiji2-pcs mailing list