From vilanova at snf.stanford.edu Tue May 1 10:31:13 2007 From: vilanova at snf.stanford.edu (vilanova at snf.stanford.edu) Date: Tue, 1 May 2007 10:31:13 -0700 Subject: Problem headway2 SNF 2007-04-30 16:47:02: I need to use the system at 6000 rpm Message-ID: Aligned Motor, Cleaned CHucks and also replaced O-rings ( I left some extra Small Orings just in case the ones in the chuck get dirty or Old ) Cycled wafer , Good to use. From mschrier at snf.stanford.edu Thu May 10 23:02:51 2007 From: mschrier at snf.stanford.edu (mschrier at snf.stanford.edu) Date: Thu, 10 May 2007 23:02:51 -0700 Subject: Shutdown headway2 SNF 2007-05-10 23:02:50: Headway will not spin Message-ID: Was working fine at 2k rpm and then started to decelerate when it should have been accelerating. Chuck has vacuum, tried another chuck, disabled and enabled, timer was on 2 min, tried other times, tried other speeds... Sorry... I hope I did not kill it! From vilanova at snf.stanford.edu Fri May 11 07:16:15 2007 From: vilanova at snf.stanford.edu (vilanova at snf.stanford.edu) Date: Fri, 11 May 2007 07:16:15 -0700 Subject: Shutdown headway2 SNF 2007-05-10 23:02:50: Headway will not spin Message-ID: I found a wrong AMP fuse In the controller , I put it the correct one and Viola! System working Fine, Ok to use.