From jhaydon at snf.stanford.edu Wed Dec 1 13:33:06 2004 From: jhaydon at snf.stanford.edu (jhaydon at snf.stanford.edu) Date: Wed, 1 Dec 2004 13:33:06 -0800 Subject: Shutdown innotec SNF 2004-11-30 15:36:31: down for regen last regen didn't take Message-ID: regen complete ok to use From parco at snf.stanford.edu Wed Dec 1 14:35:31 2004 From: parco at snf.stanford.edu (parco at snf.stanford.edu) Date: Wed, 1 Dec 2004 14:35:31 -0800 Subject: Shutdown innotec SNF 2004-12-01 14:35:30: problems: spindle/cog for the planetary Message-ID: spindle/cog for the palnetary is not seating well. it creates unusual noises ranging from low to medium to loud grinding sounds. in addition, it also created fine metal particulates on the outside planetary. tried several repositioning to properly align the bell chamber to eliminate the noises and to ensure good rotation. left Al target (C-2) and Ti target (C-3) in their respective crucible sites. From jperez at snf.stanford.edu Thu Dec 2 15:29:54 2004 From: jperez at snf.stanford.edu (jperez at snf.stanford.edu) Date: Thu, 2 Dec 2004 15:29:54 -0800 Subject: Shutdown innotec SNF 2004-12-01 14:35:30: problems: spindle/cog for the planetary Message-ID: System repaired, but you need to becareful when lowering the bell jar that the inner shield doesn't catch on to the four pillareds. Make sure the ATM light goes off within ten seconds once the vaccum gauge shows that the cryo is pumping. From hpbae at snf.stanford.edu Thu Dec 9 09:13:06 2004 From: hpbae at snf.stanford.edu (hpbae at snf.stanford.edu) Date: Thu, 9 Dec 2004 09:13:06 -0800 Subject: Problem innotec SNF 2004-12-09 09:13:06: Crystal failure, needs replacement Message-ID: I looked for a new crystal, but the two (seemingly) new ones that were in the drawer didn't work. From jperez at snf.stanford.edu Fri Dec 10 08:54:32 2004 From: jperez at snf.stanford.edu (jperez at snf.stanford.edu) Date: Fri, 10 Dec 2004 08:54:32 -0800 Subject: Problem innotec SNF 2004-12-09 09:13:06: Crystal failure, needs replacement Message-ID: Misunderstanding, didn't know how to change crystal From jimkruger at snf.stanford.edu Mon Dec 13 17:45:09 2004 From: jimkruger at snf.stanford.edu (jimkruger at snf.stanford.edu) Date: Mon, 13 Dec 2004 17:45:09 -0800 Subject: Problem innotec SNF 2004-12-13 17:45:08: planetary running "jerky" Message-ID: during my run after the gun lit up, I could see the planetary rotation was not smooth, but not too bad. After venting, I checked agagain-- it still runs with a jerk but may be OK for most depositions (uniformity a little compromised?) From ratiug at snf.stanford.edu Tue Dec 14 23:26:05 2004 From: ratiug at snf.stanford.edu (ratiug at snf.stanford.edu) Date: Tue, 14 Dec 2004 23:26:05 -0800 Subject: Problem innotec SNF 2004-12-14 23:26:04: crystal keep failure Message-ID: