From barlian at snf.stanford.edu Mon May 2 11:37:37 2005 From: barlian at snf.stanford.edu (barlian at snf.stanford.edu) Date: Mon, 2 May 2005 11:37:37 -0700 Subject: Problem karlsuss2 SNF 2005-05-02 11:37:36: left BSA illumination is weak Message-ID: it's much weaker than the right one... it's hard to focus and see anything... From vilanova at snf.stanford.edu Mon May 2 13:33:05 2005 From: vilanova at snf.stanford.edu (vilanova at snf.stanford.edu) Date: Mon, 2 May 2005 13:33:05 -0700 Subject: Problem karlsuss2 SNF 2005-05-02 11:37:36: left BSA illumination is weak Message-ID: adjusted lamp intensity , ok to use . From vilanova at snf.stanford.edu Mon May 2 13:33:24 2005 From: vilanova at snf.stanford.edu (vilanova at snf.stanford.edu) Date: Mon, 2 May 2005 13:33:24 -0700 Subject: Comment karlsuss2 SNF 2005-04-15 16:43:48: Reservation cancelled Message-ID: comment cleared. From lindaw at snf.stanford.edu Sun May 22 11:54:05 2005 From: lindaw at snf.stanford.edu (lindaw at snf.stanford.edu) Date: Sun, 22 May 2005 11:54:05 -0700 Subject: Problem karlsuss2 SNF 2005-05-22 11:54:04: microscope up move time out error message Message-ID: found the aligner with a microscope up move time out error message. The microscope is moved higher than normal and the lamp housing is all the way back further than normal. The enter light is blinking, but pressing it only get a "machine starting' message for a couple of seconds, then it goes back to the microscope up move time out error and beeping. From vilanova at snf.stanford.edu Mon May 23 07:20:08 2005 From: vilanova at snf.stanford.edu (vilanova at snf.stanford.edu) Date: Mon, 23 May 2005 07:20:08 -0700 Subject: Problem karlsuss2 SNF 2005-05-22 11:54:04: microscope up move time out error message Message-ID: lamp house and microscope found out of position. reseted and initialized system , ok to use. From pnataraj at snf.stanford.edu Mon May 23 15:00:05 2005 From: pnataraj at snf.stanford.edu (pnataraj at snf.stanford.edu) Date: Mon, 23 May 2005 15:00:05 -0700 Subject: Shutdown karlsuss2 SNF 2005-05-23 15:00:04: z-axis error Message-ID: machine says max z axis travel range exceeded please use flasher button to recover. Manahaz asked me to shut it down From martinez at snf.stanford.edu Mon May 23 15:26:47 2005 From: martinez at snf.stanford.edu (martinez at snf.stanford.edu) Date: Mon, 23 May 2005 15:26:47 -0700 Subject: Shutdown karlsuss2 SNF 2005-05-23 15:00:04: z-axis error Message-ID: reset system, set up grab z cycled test wafer cont/cont