From dton at snf.stanford.edu Tue Oct 12 12:14:50 2010 From: dton at snf.stanford.edu (dton at snf.stanford.edu) Date: Tue, 12 Oct 2010 12:14:50 -0700 Subject: Shutdown karlsuss2 SNF 2010-10-12 12:14:50: The machine is in a BAD state Message-ID: When I got the the machine it asked to press "LOAD"... (I guess someone must have reset it)... I pressed LOAD but the machine failed to initialize. Dinh Ton From vilanova at snf.stanford.edu Tue Oct 12 13:30:25 2010 From: vilanova at snf.stanford.edu (vilanova at snf.stanford.edu) Date: Tue, 12 Oct 2010 13:30:25 -0700 Subject: Shutdown karlsuss2 SNF 2010-10-12 12:14:50: The machine is in a BAD state Message-ID: Y Micrometer was Pulled out of the socket, Re Installed It tested, ok to use. From gsosa at snf.stanford.edu Mon Oct 18 09:32:27 2010 From: gsosa at snf.stanford.edu (gsosa at snf.stanford.edu) Date: Mon, 18 Oct 2010 09:32:27 -0700 Subject: Comment karlsuss2 SNF 2010-10-18 09:32:27: Lamp Change 10/18 Message-ID: Scheduled lamp change. Adjusted lamp position for max intensity. Calibrated lamp power supply for 15.0 Mw/cm2 intensity. Uniformity at 2.5% From mislam at snf.stanford.edu Sat Oct 23 22:19:42 2010 From: mislam at snf.stanford.edu (mislam at snf.stanford.edu) Date: Sat, 23 Oct 2010 22:19:42 -0700 Subject: Problem karlsuss2 SNF 2010-10-23 22:19:41: Theta micrometer loose Message-ID: It seems to be out of it's slot and not engaged. Aligner is not operational for alignment purpose. From gsosa at snf.stanford.edu Mon Oct 25 08:14:36 2010 From: gsosa at snf.stanford.edu (gsosa at snf.stanford.edu) Date: Mon, 25 Oct 2010 08:14:36 -0700 Subject: Problem karlsuss2 SNF 2010-10-23 22:19:41: Theta micrometer loose Message-ID: The theta micrometer slipped out of its mounting collar. Re-installed micrometer and tightened up the mounting collar. Tested theta travel. All OK.