From jperez at snf.stanford.edu Wed Mar 6 11:48:01 2002 From: jperez at snf.stanford.edu (Jeannie Perez) Date: Wed, 06 Mar 2002 11:48:01 -0800 Subject: New drawer installed Message-ID: <3C867271.743D55BA@snf.stanford.edu> Hello Everyone, Jim H. has installed a drawer in the Metalica, where we will keep our supplies (flashlight, tweezers, disposal bags, transfer box, etc.) We no longer have Bin A 33. Best Regards, Jeannie Perez -------------- next part -------------- An HTML attachment was scrubbed... URL: From mrolandi at stanford.edu Thu Mar 7 11:16:13 2002 From: mrolandi at stanford.edu (Marco Rolandi) Date: Thu, 7 Mar 2002 11:16:13 -0800 (PST) Subject: not using res (fwd) Message-ID: this morning 10am to 2pm, my sample is not ready sorry for the late notice marco ------------------------------------------------------------------------------- Marco Rolandi Graduate Student Department of Applied Physics Dai Group Department of Chemistry Stanford University Stanford, 94305 phone: (650) 725-9156 fax : (650) 725-9793 From jperez at snf.stanford.edu Fri Mar 8 17:27:02 2002 From: jperez at snf.stanford.edu (Jeannie Perez) Date: Fri, 08 Mar 2002 17:27:02 -0800 Subject: New Panel "Metalica Target Tester" box Message-ID: <3C8964E6.801BCA8B@snf.stanford.edu> Last minute up-date on new panel installed on the Metalica! To test the target for adequate resistance, you no longer need to use the OHM meter. What you now do is to toggle the switch labeled test to the up position and the green LED above the switch will light, indicating that you are in the test mode. To the right you will note that there is another switch labeled "Target A and Target B, the yellow LED indicated which target you have selected. Further to the right you will note there is a green LED that indicated that the target selected is OK and a red LED that indicates that the target is NOT OK. If the red LED is lit then the resistance is below 200 Ohms and must be corrected. If the Green LED is on after you have secured your target then it should be ok to use. After you have installed your target and you go to the HV ENABLE mode with the switch in the down position, then a red LED that indicates HIGH VOLTAGE ENABLED will be lit. The LED that indicates that the target is OK will also be lit, this is normal. The new specifications on these changes are in the operating procedure! Any additional information or training see Jim Haydon or Jeannie Perez From cmrlgr at earthlink.net Mon Mar 11 12:31:39 2002 From: cmrlgr at earthlink.net (Claudia Richter) Date: Mon, 11 Mar 2002 12:31:39 -0800 Subject: cancelled reservation for Metalica on Monday from 3pm to 6pm Message-ID: <000001c1c93b$c3a86110$6501a8c0@DBY5GYNZ> Sorry for the late notice. Claudia -------------- next part -------------- An HTML attachment was scrubbed... URL: From jperez at snf.stanford.edu Mon Mar 11 14:31:35 2002 From: jperez at snf.stanford.edu (Jeannie Perez) Date: Mon, 11 Mar 2002 14:31:35 -0800 Subject: In Regen until tomorrow morning 3/12/02,temp.too high Message-ID: <3C8D3047.5DD2C6B8@snf.stanford.edu>