From jperez at snf.stanford.edu Thu Aug 26 16:14:36 2004 From: jperez at snf.stanford.edu (Jeannie Perez) Date: Thu, 26 Aug 2004 16:14:36 -0700 Subject: Metalica Target Status Tester is back up! Message-ID: <412E6EDB.5650F674@snf.stanford.edu> You no longer have to use the Ohms meter! Go back to using the Metalica target status tester, switching to desired (A /B toggle) targets while assembling your targets for good resistance above 200K Ohms (Green LED should be lit.).. -- Jeannie Perez Science and Engineering Technician Stanford Nanofabrication Facility Stanford University Tel: (650) 723-7997 Fax: (650) 725-6278 -------------- next part -------------- An HTML attachment was scrubbed... URL: From jperez at snf.stanford.edu Fri Aug 27 09:02:14 2004 From: jperez at snf.stanford.edu (Jeannie Perez) Date: Fri, 27 Aug 2004 09:02:14 -0700 Subject: LED lights on Metalica Message-ID: <412F5B06.37217D6D@snf.stanford.edu> All Users, When inserting all parts back into Metalica when depositions have been completed, please make sure that the LED lights are NOT flickering. Must be either a solid GREEN or solid RED. Jim Haydon believes it wears down the chip he just had to replace in the Metalica target tester. Sometimes you may have to screw down one of the anode screws to keep it from flickering. It don't matter which light is ON. Any questions, please see Jim Haydon. Thanks, -- Jeannie Perez Science and Engineering Technician Stanford Nanofabrication Facility Stanford University Tel: (650) 723-7997 Fax: (650) 725-6278