From emyers at snf.stanford.edu Mon Mar 1 09:24:17 2010 From: emyers at snf.stanford.edu (emyers at snf.stanford.edu) Date: Mon, 1 Mar 2010 09:24:17 -0800 Subject: Problem micromanipulator6000 SNF 2010-01-04 13:47:53: Micromanipulators Message-ID: All 4 manipulators were repaired, at least for today. From shott at snf.stanford.edu Wed Mar 10 18:51:03 2010 From: shott at snf.stanford.edu (shott at snf.stanford.edu) Date: Wed, 10 Mar 2010 18:51:03 -0800 Subject: Problem micromanipulator6000 SNF 2010-02-28 22:51:58: Tips need to be changed Message-ID: Net tips ... From shott at snf.stanford.edu Wed Mar 10 18:51:13 2010 From: shott at snf.stanford.edu (shott at snf.stanford.edu) Date: Wed, 10 Mar 2010 18:51:13 -0800 Subject: Comment micromanipulator6000 SNF 2010-02-10 18:54:17: Probe Pins Message-ID: Net tips ... From shott at snf.stanford.edu Wed Mar 31 16:20:20 2010 From: shott at snf.stanford.edu (shott at snf.stanford.edu) Date: Wed, 31 Mar 2010 16:20:20 -0700 Subject: Comment micromanipulator6000 SNF 2010-03-31 16:20:20: Z-axis repaired ... Message-ID: Probing community: I've replaced the damaged brass threaded piece that controls the vertical position of the stage with a newly machined piece. The vertical axis now works very nicely and the probes have been adjusted so that the probe stage can be in the middle of the "sweet spot" as indicated by the tape on the left near the left lever. If you think you need to move the chuck height beyond this range ... DON'T!... Thanks, John