Magnetic Polymer in Metallica?

Jeannie Perez jperez at snf.stanford.edu
Thu May 21 07:49:31 PDT 2009


Hi,
I also don't see a problem with this process in Metalica.
Jeannie

At 03:01 PM 5/20/2009, Mary Tang wrote:
>Hi Nathan --
>
>I don't think this is a problem, but am forwarding to SpecMat, just 
>for the record.  Jeannie, Ed, what do you think?
>
>Mary
>
>Nathan K wrote:
>>Metal Quality Circle,
>>
>>I would like to try sputtering metal using Metallica on my printed
>>polystyrene-iron composite material (the same material that caused no
>>trouble in XeF2 (see attached)) on silicon substrates to do metal
>>liftoff.  The polymer shows excellent adhesion to the substrate, so
>>there should be no particulate problems, withstands temperatures up to
>>100C, and is solvent free, so there should be minimal outgassing.  Do
>>you forsee any problems, or can I go ahead and run a test?  I would
>>appreciate your input.
>>
>>Regards,
>>Nathan Klejwa
>>
>>
>>------------------------------------------------------------------------
>
>
>--
>Mary X. Tang, Ph.D.
>Stanford Nanofabrication Facility
>CIS Room 136, Mail Code 4070
>Stanford, CA  94305
>(650)723-9980
>mtang at stanford.edu
>http://snf.stanford.edu
>

Jeannie Perez
Science and Engineering Technician
Stanford Nanofabrication Facility
Stanford University
Tel: (650) 723-7997
Fax: (650) 725-6278

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://snf.stanford.edu/pipermail/specmat/attachments/20090521/2418b4c7/attachment.html>


More information about the specmat mailing list