From mahnaz at stanford.edu  Tue Mar 15 15:50:01 2011
From: mahnaz at stanford.edu (Mahnaz Mansourpour)
Date: Tue, 15 Mar 2011 15:50:01 -0700
Subject: Please read
Message-ID: <4D7FED19.50803@stanford.edu>


Hello all,

When the lifter on the svgcoat 2 mis-behaves please do not shut down the 
track because all ASML users use the the YES oven and they do not need 
to use the prime on the track.
  I asked Gary for an explanation on the issue so the issue is caused by 
resetting the track from the panel and NOT DOING IT FROM THE MONITOR ( 
correct way).

mahnaz

Here is Gray's explanation

  This is an intermittent problem with the power up sequence. The only time it happens is when the track is powered down and powered up at the track controller, probably by a user trying to reset the track. Sometimes, not all the time, the lifters on the vapor prime will get stuck. If the track is reset using the recipe manager, and doing a track reset, it never fails. We have tried replacing the I/O board and the lifter mechanism so far. We need to re-reinforce the the track users that the proper way to reset the track is through the recipe manager computer and not by the track controller.