From lindaw at snf.stanford.edu Mon Dec 3 09:24:47 2007 From: lindaw at snf.stanford.edu (lindaw at snf.stanford.edu) Date: Mon, 3 Dec 2007 09:24:47 -0800 Subject: Problem svgdev SNF 2007-12-03 09:24:46: load indexer belts stop turning before wafer Message-ID: load indexer belts stop turning before wafer has left the load cassette, thus the wafer will not auto load. Previous user states that even in manual, the wafer loads into position over chuck, but does not does not load onto chuck, it just sits there. From vilanova at snf.stanford.edu Mon Dec 3 10:24:53 2007 From: vilanova at snf.stanford.edu (vilanova at snf.stanford.edu) Date: Mon, 3 Dec 2007 10:24:53 -0800 Subject: Problem svgdev SNF 2007-12-03 09:24:46: load indexer belts stop turning before wafer Message-ID: attached wafer sensor to wafer carrier, cycled wafers Ok to use. From linyoucao at snf.stanford.edu Thu Dec 6 04:30:07 2007 From: linyoucao at snf.stanford.edu (linyoucao at snf.stanford.edu) Date: Thu, 6 Dec 2007 04:30:07 -0800 Subject: Problem svgdev SNF 2007-12-06 04:30:05: transfer not work very well Message-ID: transfer not work very well From gsosa at snf.stanford.edu Thu Dec 6 08:29:22 2007 From: gsosa at snf.stanford.edu (gsosa at snf.stanford.edu) Date: Thu, 6 Dec 2007 08:29:22 -0800 Subject: Problem svgdev SNF 2007-12-06 04:30:05: transfer not work very well Message-ID: Tested track in auto mode. All tested OK. From shanewang at snf.stanford.edu Fri Dec 7 11:58:38 2007 From: shanewang at snf.stanford.edu (shanewang at snf.stanford.edu) Date: Fri, 7 Dec 2007 11:58:38 -0800 Subject: Problem svgdev SNF 2007-12-07 11:58:38: spin time changed by somebody Message-ID: In Prog 3 both event 4 and 7 spin times were changed to 22s by someone, `they were changed back to 30s. From vilanova at snf.stanford.edu Fri Dec 7 14:24:51 2007 From: vilanova at snf.stanford.edu (vilanova at snf.stanford.edu) Date: Fri, 7 Dec 2007 14:24:51 -0800 Subject: Problem svgdev SNF 2007-12-07 11:58:38: spin time changed by somebody Message-ID: someone changed the spin time and some other event on program 3, 7, i put them back to the normal cycles, please if you change something ( speed time event, ) change it back to the normal cycles after you use them . From vilanova at snf.stanford.edu Wed Dec 19 07:21:09 2007 From: vilanova at snf.stanford.edu (vilanova at snf.stanford.edu) Date: Wed, 19 Dec 2007 07:21:09 -0800 Subject: Shutdown svgdev SNF 2007-12-19 07:21:08: holiday shutdown Message-ID: