From ahazeghi at snf.stanford.edu Fri Aug 8 19:12:54 2008 From: ahazeghi at snf.stanford.edu (ahazeghi at snf.stanford.edu) Date: Fri, 8 Aug 2008 19:12:54 -0700 Subject: Problem svgdev2 SNF 2008-08-08 19:12:53: Wafers do not process to reciever Message-ID: wafer stays on top of hot plate and does not proceed to reciever. program and times are OK, please check. From vilanova at snf.stanford.edu Mon Aug 11 07:36:39 2008 From: vilanova at snf.stanford.edu (vilanova at snf.stanford.edu) Date: Mon, 11 Aug 2008 07:36:39 -0700 Subject: Problem svgdev2 SNF 2008-08-08 19:12:53: Wafers do not process to reciever Message-ID: Cycled wafers I could not repeat the problem, Someone picked up the wafer before it went into the receiving cassette therefore when someone else Use it the receiver cassette sensor was waiting for a wafers. ok to use.- From gsosa at snf.stanford.edu Mon Aug 18 15:40:04 2008 From: gsosa at snf.stanford.edu (gsosa at snf.stanford.edu) Date: Mon, 18 Aug 2008 15:40:04 -0700 Subject: Comment svgdev2 SNF 2008-08-18 15:40:04: Power failure recovery Message-ID: Powered up the track and stabilized hot plates. Tested wafer handling. All looks OK. From lindaw at snf.stanford.edu Sat Aug 23 16:59:10 2008 From: lindaw at snf.stanford.edu (lindaw at snf.stanford.edu) Date: Sat, 23 Aug 2008 16:59:10 -0700 Subject: Comment svgdev2 SNF 2008-08-23 16:59:10: "resist" on hot plate Message-ID: There is some spots of red resist looking substance on the hot plate. I tried to remove with acetone, but it does not come off. Don't know what it is. From vilanova at snf.stanford.edu Mon Aug 25 14:02:48 2008 From: vilanova at snf.stanford.edu (vilanova at snf.stanford.edu) Date: Mon, 25 Aug 2008 14:02:48 -0700 Subject: Comment svgdev2 SNF 2008-08-23 16:59:10: "resist" on hot plate Message-ID: cleaned earlier today .-