From caudillo at snf.stanford.edu Thu Jul 12 04:47:47 2001 From: caudillo at snf.stanford.edu (caudillo at snf.stanford.edu) Date: Jul 12, 2001 4:47:47 PM Subject: Shutdown tylan1 2001-07-12 16:47:43: center zone is out. Message-ID: From seymour at snf.stanford.edu Fri Jul 13 11:18:52 2001 From: seymour at snf.stanford.edu (seymour at snf.stanford.edu) Date: Jul 13, 2001 11:18:52 AM Subject: Shutdown tylan1 2001-07-12 16:47:43: center zone is out. Message-ID: swapped TCU board and inputed profile t/c deviations. System up to temp and all t/c reading good. From ericp at snf.stanford.edu Sat Jul 14 06:17:06 2001 From: ericp at snf.stanford.edu (ericp at snf.stanford.edu) Date: Jul 14, 2001 6:17:06 PM Subject: Problem tylan1 2001-07-14 18:17:04: TEMPL runs low Message-ID: On a 1050 (wet oxidation) run, the TEMPL is about 1020, while TEMPC and TEMPS run about 1055. TCU reports 100% on the TEMPL end, and about 33% for the other two zones. Users should probably not use this tube for critical work until it is fixed! -Eric From seymour at snf.stanford.edu Mon Jul 16 01:17:12 2001 From: seymour at snf.stanford.edu (seymour at snf.stanford.edu) Date: Jul 16, 2001 1:17:12 PM Subject: Shutdown tylan1 2001-07-16 13:17:12: load zone power problem Message-ID: From seymour at snf.stanford.edu Tue Jul 17 08:32:40 2001 From: seymour at snf.stanford.edu (seymour at snf.stanford.edu) Date: Jul 17, 2001 8:32:40 AM Subject: Shutdown tylan1 2001-07-16 13:17:12: load zone power problem Message-ID: the load zone is running a little low. Eric said the oxidation was pretty uniform in his run, as the center zone is at temp and flat. I will leave the system up for operation untill I need to take it down for parts replacement. From gladys at snf.stanford.edu Thu Jul 26 06:35:02 2001 From: gladys at snf.stanford.edu (gladys at snf.stanford.edu) Date: Jul 26, 2001 6:35:02 PM Subject: Problem tylan1 2001-07-26 18:35:00: tylan1:15% off the target thickness, front is 20% off Message-ID: