TUBE IDLE TEMPERATURE

Eric Perozziello eap at gloworm.Stanford.EDU
Fri Mar 20 15:10:18 PDT 2009


Folks, please, if you run a process in tylan 1 thru 4 that
is less than 800C, PLEASE load 800AN or something similar to
cause the tube to ramp back up to idle.  No need to run
the program, just merely load the 800AN program, type in any
time, and then do no run it.  That's all you need to do.

It takes HOURS for the tube to properly stabilize at
elevated temperature.

Today, several tubes were left at 500C.

Thanks





More information about the tylan1 mailing list