From fsoo at snf.stanford.edu Tue Jun 12 02:51:42 2001 From: fsoo at snf.stanford.edu (fsoo at snf.stanford.edu) Date: Jun 12, 2001 2:51:42 PM Subject: Comment wafersaw 2001-06-12 14:51:41: can't get calibration Message-ID: tried according to manual to get height calibration checked for spin up, spin ok when I hit height, stage moves, microscope is centered press enter, nothing happens, just a beep press enter again, nothing happens, just a beep. tried backing all the way out, disable, enable, again, no go. double checked motor spinning thanks! Fred Soo From damaids at snf.stanford.edu Thu Jun 28 11:24:34 2001 From: damaids at snf.stanford.edu (damaids at snf.stanford.edu) Date: Jun 28, 2001 11:24:34 AM Subject: Problem wafersaw 2001-06-28 11:24:30: wafersaw index II not 90 degrees Message-ID: I use the autocut feature on the wafersaw, and normally after the index I cut, it rotates 90 degrees to index 2. but the rotation is about a degree or so off right now. it is a little troubling. --dan maidenberg From ericp at snf.stanford.edu Thu Jun 28 10:46:46 2001 From: ericp at snf.stanford.edu (ericp at snf.stanford.edu) Date: Jun 28, 2001 10:46:46 PM Subject: Problem wafersaw 2001-06-28 22:46:44: Interlock Bad, theta good Message-ID: The coral interlock is stuck "on". The theta rotation seems to be normal. From mtang at snf.stanford.edu Fri Jun 29 04:40:51 2001 From: mtang at snf.stanford.edu (mtang at snf.stanford.edu) Date: Jun 29, 2001 4:40:51 PM Subject: Problem wafersaw 2001-06-29 16:40:49: Bad CORAL interlock Message-ID: