From renuart at snf.stanford.edu Wed Nov 14 04:25:53 2001 From: renuart at snf.stanford.edu (renuart at snf.stanford.edu) Date: Nov 14, 2001 4:25:53 PM Subject: Shutdown wafersaw 2001-11-14 16:25:51: Blade stuck on spindle Message-ID: The set screw to hold the blade in place will not come loose from the spindle. From cbaxter at snf.stanford.edu Wed Nov 14 06:23:39 2001 From: cbaxter at snf.stanford.edu (cbaxter at snf.stanford.edu) Date: Nov 14, 2001 6:23:39 PM Subject: Shutdown wafersaw 2001-11-14 16:25:51: Blade stuck on spindle Message-ID: eric, said blade was not stuck at all. change back to silicon blade and tested........ From damaids at snf.stanford.edu Fri Nov 30 11:24:46 2001 From: damaids at snf.stanford.edu (damaids at snf.stanford.edu) Date: Nov 30, 2001 11:24:46 AM Subject: Comment wafersaw 2001-11-30 11:24:46: vacuum pump rattling Message-ID: No problem at all, but during some long auto-cuts the vacuum pump started to rattle a pretty good bit. maybe it needs a tune-up (or a replacement? that thing must be at least as old as the saw itself). that's all --dan