From rjchen at snf.stanford.edu Fri Oct 26 12:28:02 2001 From: rjchen at snf.stanford.edu (rjchen at snf.stanford.edu) Date: Oct 26, 2001 12:28:02 PM Subject: Problem wafersaw 2001-10-26 12:28:00: saw blade stuck Message-ID: Just finished cutting a quartz wafer with a 3060 saw blade. As I was cleaning up, I discovered I could not remove the blade. Normally I can get it off by wiggling it slightly, but it seems stuck pretty tight this time. From mtang at snf.stanford.edu Fri Oct 26 01:16:02 2001 From: mtang at snf.stanford.edu (mtang at snf.stanford.edu) Date: Oct 26, 2001 1:16:02 PM Subject: Problem wafersaw 2001-10-26 12:28:00: saw blade stuck Message-ID: Removed blade. Did this several times -- a little sticky, but seems OK. Recommend wiping the spindle and the inside of the blade with a cleanwipe before mounting to make sure there's no grit between the blade and spindle. From krishnan at snf.stanford.edu Sat Oct 27 07:23:28 2001 From: krishnan at snf.stanford.edu (krishnan at snf.stanford.edu) Date: Oct 27, 2001 7:23:28 PM Subject: Problem wafersaw 2001-10-27 19:23:27: Saw blade stuck Message-ID: There is an S3060 saw blade mounted on the wafersaw. I tried to remove it and replace it with my S3030, however the existing one is stuck. During my repeated attempts to pry it off, I ended up peeling off its outer cutting ring. This blade needs to be removed and discarded before anyone else can use the wafersaw. From booth at snf.stanford.edu Mon Oct 29 06:47:57 2001 From: booth at snf.stanford.edu (booth at snf.stanford.edu) Date: Oct 29, 2001 6:47:57 AM Subject: Shutdown wafersaw 2001-10-29 06:47:56: Spindle is damaged Message-ID: need to repair spindle. From booth at snf.stanford.edu Mon Oct 29 09:30:28 2001 From: booth at snf.stanford.edu (booth at snf.stanford.edu) Date: Oct 29, 2001 9:30:28 AM Subject: Problem wafersaw 2001-10-27 19:23:27: Saw blade stuck Message-ID: From booth at snf.stanford.edu Mon Oct 29 09:33:17 2001 From: booth at snf.stanford.edu (booth at snf.stanford.edu) Date: Oct 29, 2001 9:33:17 AM Subject: Shutdown wafersaw 2001-10-29 06:47:56: Spindle is damaged Message-ID: Spindle has been surfaced to clean up damaged area. Two spare blades slide all the way onto the spindle with no resistance.