From crichter at snf.stanford.edu Mon Oct 13 12:52:11 2003 From: crichter at snf.stanford.edu (crichter at snf.stanford.edu) Date: Oct 13, 2003 12:52:11 PM Subject: Shutdown wafersaw 2003-10-13 12:52:10: limit offset status message on x- axis bad Message-ID: ...and last two cuts left to do on substrate, then blade broke From booth at snf.stanford.edu Mon Oct 13 01:46:52 2003 From: booth at snf.stanford.edu (booth at snf.stanford.edu) Date: Oct 13, 2003 1:46:52 PM Subject: Shutdown wafersaw 2003-10-13 12:52:10: Report Clear for wafersaw Message-ID: restarted saw, checked all parameters. From holdenli at snf.stanford.edu Sat Oct 18 03:56:26 2003 From: holdenli at snf.stanford.edu (holdenli at snf.stanford.edu) Date: Oct 18, 2003 3:56:26 PM Subject: Comment wafersaw 2003-10-18 15:56:25: Run out of blue tape Message-ID: There is no more blue tape on the shelf. You should consider only using this machine during office hours. The previous user should have put some blue tape. From apanda at snf.stanford.edu Wed Oct 22 06:20:18 2003 From: apanda at snf.stanford.edu (apanda at snf.stanford.edu) Date: Oct 22, 2003 6:20:18 PM Subject: Problem wafersaw 2003-10-22 18:20:17: Problem : Countdown not complete Message-ID: The countdown from 30 upon initial startup is stuck at 14. The utility monitor reports all system checks as OK. The power display on the Power Saw reports NO POWER (countdown not completed). Tried disabling and re-enabling the system a few times, including logging in and out. Does not work. Seems like a system glitch and not an account or a software one. From sumita at snf.stanford.edu Wed Oct 22 09:56:48 2003 From: sumita at snf.stanford.edu (sumita at snf.stanford.edu) Date: Oct 22, 2003 9:56:48 PM Subject: Shutdown wafersaw 2003-10-22 21:56:48: software glitch Message-ID: Didn't see problem apanda found. My glitch was when wafersaw can't unload after you calibrate height since it goes all the way to the right and says I must reset axis. Combined with apanda's problem, I thought it may be a limit switch which could potentially break the system so I shut it down. From booth at snf.stanford.edu Thu Oct 23 09:40:59 2003 From: booth at snf.stanford.edu (booth at snf.stanford.edu) Date: Thu, 23 Oct 2003 09:40:59 -0700 Subject: Problem wafersaw 2003-10-22 18:20:17: Report Clear for wafersaw Message-ID: sumita changed this to a shutdown report From booth at snf.stanford.edu Thu Oct 23 09:41:53 2003 From: booth at snf.stanford.edu (booth at snf.stanford.edu) Date: Thu, 23 Oct 2003 09:41:53 -0700 Subject: Shutdown wafersaw 2003-10-22 21:56:48: Report Clear for wafersaw Message-ID: System logic was confused. Restarted system firmware, did calibration and test cut - runs OK again.