Comment wafersaw SNF 2005-05-19 20:56:32: Not properly left

sjo at snf.stanford.edu sjo at snf.stanford.edu
Thu May 19 20:56:33 PDT 2005


I found the wafersaw in a disarrayed state - the instructions and the red box were left in the wrong places, all the settings were off - the chuck was at 45 degrees, the spindle height and reticle focus set to cut a 1 inch thick and 3 inch diameter wafer, all units set to inches, and the metric units were way off their default values. Fortunately it did work for me in the end but whoever left it like that should clean up better after themselves.




More information about the wafersaw-pcs mailing list