Problem wafersaw SNF 2009-01-14 11:39:13: Low N2?

mtang at snf.stanford.edu mtang at snf.stanford.edu
Wed Jan 14 11:39:13 PST 2009


The system would not start because of low air, although you can clearly hear it and the incoming pressure is good.  The side panel was still off, since work on the slight leak continues.  A regulator was sticking out -- wiggling the regulator line causes this low air error to go off and on.  Since Prabhu really wants to use it, we gently placed it so that it stays on.  But the plan is to put this down when he is done.




More information about the wafersaw-pcs mailing list