From gyama at snf.stanford.edu Mon Mar 1 13:03:58 2010 From: gyama at snf.stanford.edu (gyama at snf.stanford.edu) Date: Mon, 1 Mar 2010 13:03:58 -0800 Subject: Problem wafersaw SNF 2010-03-01 13:03:58: blade slams into wafer 1/2 way through Message-ID: I start at the back of the wafer & single cut. After the cuts reaches about 1/2 way, the blade comes down on the wafer rather than coming down just before it. From kattsai at snf.stanford.edu Wed Mar 3 12:03:55 2010 From: kattsai at snf.stanford.edu (kattsai at snf.stanford.edu) Date: Wed, 3 Mar 2010 12:03:55 -0800 Subject: Problem wafersaw SNF 2010-03-03 12:03:54: Water leak Message-ID: There is a puddle of water to the right of the tool. Not sure where the water is coming from. From allenc at snf.stanford.edu Wed Mar 17 19:25:54 2010 From: allenc at snf.stanford.edu (allenc at snf.stanford.edu) Date: Wed, 17 Mar 2010 19:25:54 -0700 Subject: Problem wafersaw SNF 2010-03-17 19:25:53: water leakage Message-ID: The water leakage that previous user reported seems to be coming from the pump on the floor.. Observed some water leaking from it while pumping.. From mkuemmel at snf.stanford.edu Thu Mar 25 09:53:03 2010 From: mkuemmel at snf.stanford.edu (mkuemmel at snf.stanford.edu) Date: Thu, 25 Mar 2010 09:53:03 -0700 Subject: Problem wafersaw SNF 2010-03-25 09:53:02: screw for O-ring for the chuck vavuum pin Message-ID: O-ring was not in the position for the 4" wafers, but for smaller wafers. Could not change position because screw is too tight. From cbaxter at snf.stanford.edu Sat Mar 27 12:00:52 2010 From: cbaxter at snf.stanford.edu (cbaxter at snf.stanford.edu) Date: Sat, 27 Mar 2010 12:00:52 -0700 Subject: Problem wafersaw SNF 2010-03-25 09:53:02: screw for O-ring for the chuck vavuum pin Message-ID: Was able to loosen screw for vacuum pin.