From mtang at snf.stanford.edu  Wed May  4 14:51:30 2011
From: mtang at snf.stanford.edu (mtang at snf.stanford.edu)
Date: Wed, 4 May 2011 14:51:30 -0700
Subject: Comment wafersaw SNF 2011-04-29 15:04:32: Hub Flange set/narrow exposure
Message-ID: <mailman.991.1357938994.26017.wafersaw-pcs@snf.stanford.edu>

Checked out this flange set (cut a quartz wafer into 2.5 cm pieces) and it worked fine.



From hnuhn at snf.stanford.edu  Fri May 20 10:32:06 2011
From: hnuhn at snf.stanford.edu (hnuhn at snf.stanford.edu)
Date: Fri, 20 May 2011 10:32:06 -0700
Subject: Comment wafersaw SNF 2011-05-20 10:32:05: saw cuts a street twice
Message-ID: <mailman.992.1357938994.26017.wafersaw-pcs@snf.stanford.edu>

Hi,
after having cut a street and pressing inspection, sometimes it cuts the previous street again. 
Best,
Harald
ps: I just have been told that this has happened before last week.



From jtsai at snf.stanford.edu  Fri May 20 16:04:55 2011
From: jtsai at snf.stanford.edu (jtsai at snf.stanford.edu)
Date: Fri, 20 May 2011 16:04:55 -0700
Subject: Problem wafersaw SNF 2011-05-20 16:04:54: can't align
Message-ID: <mailman.993.1357938994.26017.wafersaw-pcs@snf.stanford.edu>

the spindle moves out of range when the align button is pressed