Interlock problem

Mary Tang mtang at snf.stanford.edu
Fri Jun 29 16:46:41 PDT 2001


Hello --

As you may have noticed, the wafersaw is experiencing some
communications problems with Coral over the past couple of days.  Most
of the time, when you try to enable/disable, Coral gives you an error
message, but the machine is indeed, enabled/disabled (no feedback to
Coral?).  But now, it doesn't even seem to obey the "enable" command at
all.  So, I would not count on using the wafersaw this weekend...  We
hope to have someone knowledgeable take a look at this on Monday.

Thanks for your patience --

Mary




More information about the wafersaw mailing list