Depth of cut

[Vishal Singhal]

Hello wafer saw users,

I am planning to use the wafer saw to cut borosilicate glass (masks)
with thickness of 0.060" (approximately 1.5mm).

If anybody has experience doing this, can you tell me whether I can
cut this much depth with a single pass or should I make mutiple passes
with increasing depths.  What is the maximum recommended depth of cut
for a single cut.  Are there other recommendations for cutting quartz
and glass wafers.

Thanks,
Vishal

--
Vishal Singhal
Thorrn Micro Technologies, Inc.
650-556-1248
vishal at thorrn.com