weird offset problem

Edgar Peralta eperalta at stanford.edu
Wed Nov 28 23:54:32 PST 2012


The tool is doing that thing again where it shifts about 6mm from the
desired position.

i.e. You go do height calibration, point microscope to the center (0,0
position) and after hitting enter it moves the head towards positive Y
values all the way to the end of the chuck and tries to do the height
calibration there.

Does anyone know how to fix this? I can't afford to wait until tomorrow :(

-- 
*Edgar A. Peralta *
*Ph.D. Candidate, *Stanford University
Department of Applied Physics
*M*: 954.940.2700
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://snf.stanford.edu/pipermail/wafersaw/attachments/20121128/b687a274/attachment.html>


More information about the wafersaw mailing list