From jhaydon at snf.stanford.edu Tue Jun 1 08:06:02 2004 From: jhaydon at snf.stanford.edu (jhaydon at snf.stanford.edu) Date: Tue, 1 Jun 2004 08:06:02 -0700 Subject: Problem wbgen-ctb 2004-05-30 14:16:42: Safety Control Warning Message-ID: I probably had the safety set too low ok to use now From zappe at snf.stanford.edu Fri Jun 4 12:12:18 2004 From: zappe at snf.stanford.edu (zappe at snf.stanford.edu) Date: Fri, 4 Jun 2004 12:12:18 -0700 Subject: Problem wbgen-ctb 2004-06-04 12:12:17: The safety control ... Message-ID: .. kicked in again. Bath is not heating. From jhaydon at snf.stanford.edu Tue Jun 8 14:55:53 2004 From: jhaydon at snf.stanford.edu (jhaydon at snf.stanford.edu) Date: Tue, 8 Jun 2004 14:55:53 -0700 Subject: Problem wbgen-ctb 2004-06-04 12:12:17: The safety control ... Message-ID: adjusted over temp switch and reset From zappe at snf.stanford.edu Tue Jun 8 17:20:45 2004 From: zappe at snf.stanford.edu (zappe at snf.stanford.edu) Date: Tue, 8 Jun 2004 17:20:45 -0700 Subject: Problem wbgen-ctb 2004-06-08 17:20:43: Sorry, safety control again ... Message-ID: I think the last time it t`heated up to 50 deg C and then alarmed, now it went at least up to 70 deg C and alarmed. I would like to etch at 90 deg C. Thanks ... From jhaydon at snf.stanford.edu Wed Jun 9 12:24:40 2004 From: jhaydon at snf.stanford.edu (jhaydon at snf.stanford.edu) Date: Wed, 9 Jun 2004 12:24:40 -0700 Subject: Problem wbgen-ctb 2004-06-08 17:20:43: Sorry, safety control again ... Message-ID: reset overtemp switch to higher value we will se if this is enough