From mtang at snf.stanford.edu Tue Oct 9 16:27:15 2007 From: mtang at snf.stanford.edu (mtang at snf.stanford.edu) Date: Tue, 9 Oct 2007 16:27:15 -0700 Subject: Problem wbgen2-hp SNF 2007-10-09 16:27:15: Possible AWN Problem - do not use if AWN light flashes Message-ID: From mtang at snf.stanford.edu Mon Oct 15 09:21:18 2007 From: mtang at snf.stanford.edu (mtang at snf.stanford.edu) Date: Mon, 15 Oct 2007 09:21:18 -0700 Subject: Problem wbgen2-hp SNF 2007-10-09 16:27:15: Possible AWN Problem - do not use if AWN light flashes Message-ID: Facilities replaced tank 3 pH probe. From uli at snf.stanford.edu Mon Oct 15 10:21:58 2007 From: uli at snf.stanford.edu (uli at snf.stanford.edu) Date: Mon, 15 Oct 2007 10:21:58 -0700 Subject: Shutdown wbgen2-hp SNF 2007-10-15 10:21:57: no power Message-ID: Can't use the piranha bath. From jperez at snf.stanford.edu Tue Oct 16 14:35:17 2007 From: jperez at snf.stanford.edu (jperez at snf.stanford.edu) Date: Tue, 16 Oct 2007 14:35:17 -0700 Subject: Comment wbgen2-hp SNF 2007-10-16 14:35:14: Jim will order another power supply Message-ID: From jhaydon at snf.stanford.edu Thu Oct 18 09:10:21 2007 From: jhaydon at snf.stanford.edu (jhaydon at snf.stanford.edu) Date: Thu, 18 Oct 2007 09:10:21 -0700 Subject: Shutdown wbgen2-hp SNF 2007-10-15 10:21:57: no power Message-ID: installed new power supply From gibby at snf.stanford.edu Thu Oct 18 17:34:29 2007 From: gibby at snf.stanford.edu (gibby at snf.stanford.edu) Date: Thu, 18 Oct 2007 17:34:29 -0700 Subject: Comment wbgen2-hp SNF 2007-10-18 17:34:28: Dump Rinser will not fill while spin dryer is running Message-ID: Dump rinser (DR) works normally if "open" is not pressed. But, if the DR is drained and the spin dryer (SD) is started the DR will not refill until the SD stops. If the DR is not drained, it will work while the SD is running. From gibby at snf.stanford.edu Wed Oct 24 12:56:04 2007 From: gibby at snf.stanford.edu (gibby at snf.stanford.edu) Date: Wed, 24 Oct 2007 12:56:04 -0700 Subject: Problem wbgen2-hp SNF 2007-10-24 12:56:04: No water during spin dry. Message-ID: From jhaydon at snf.stanford.edu Wed Oct 24 16:04:50 2007 From: jhaydon at snf.stanford.edu (jhaydon at snf.stanford.edu) Date: Wed, 24 Oct 2007 16:04:50 -0700 Subject: Problem wbgen2-hp SNF 2007-10-24 12:56:04: No water during spin dry. Message-ID: someone set rinse time to zero From jhaydon at snf.stanford.edu Wed Oct 24 16:05:27 2007 From: jhaydon at snf.stanford.edu (jhaydon at snf.stanford.edu) Date: Wed, 24 Oct 2007 16:05:27 -0700 Subject: Comment wbgen2-hp SNF 2007-10-18 17:34:28: Dump Rinser will not fill while spin dryer is running Message-ID: SRD rinse time was set to zero From jhaydon at snf.stanford.edu Wed Oct 24 16:05:52 2007 From: jhaydon at snf.stanford.edu (jhaydon at snf.stanford.edu) Date: Wed, 24 Oct 2007 16:05:52 -0700 Subject: Comment wbgen2-hp SNF 2007-10-16 14:35:14: Jim will order another power supply Message-ID: new power supply installed From gibby at snf.stanford.edu Thu Oct 25 18:43:47 2007 From: gibby at snf.stanford.edu (gibby at snf.stanford.edu) Date: Thu, 25 Oct 2007 18:43:47 -0700 Subject: Problem wbgen2-hp SNF 2007-10-25 18:43:46: Temperature rise is too slow. Message-ID: After an hour of heating, a bath of 9:1 h2so4/h2o2 bath was at 90C. At an average rate of rise, it will take another 45 minutes to heat to 120C. Also, the heating seemas to be getting slower, so it will probably take longer. From gibby at snf.stanford.edu Thu Oct 25 19:04:56 2007 From: gibby at snf.stanford.edu (gibby at snf.stanford.edu) Date: Thu, 25 Oct 2007 19:04:56 -0700 Subject: Comment wbgen2-hp SNF 2007-10-25 19:04:56: remove problem; hot pot is fine Message-ID: i forgot to press set enable and enter at the same time; sorry. From jhaydon at snf.stanford.edu Fri Oct 26 08:11:43 2007 From: jhaydon at snf.stanford.edu (jhaydon at snf.stanford.edu) Date: Fri, 26 Oct 2007 08:11:43 -0700 Subject: Shutdown wbgen2-hp SNF 2007-10-26 08:11:42: down for work on scruber Message-ID: From jhaydon at snf.stanford.edu Mon Oct 29 07:56:39 2007 From: jhaydon at snf.stanford.edu (jhaydon at snf.stanford.edu) Date: Mon, 29 Oct 2007 07:56:39 -0700 Subject: Shutdown wbgen2-hp SNF 2007-10-26 08:11:42: down for work on scruber Message-ID: work completed From jhaydon at snf.stanford.edu Mon Oct 29 07:57:36 2007 From: jhaydon at snf.stanford.edu (jhaydon at snf.stanford.edu) Date: Mon, 29 Oct 2007 07:57:36 -0700 Subject: Problem wbgen2-hp SNF 2007-10-25 18:43:46: Temperature rise is too slow. Message-ID: From jhaydon at snf.stanford.edu Mon Oct 29 07:57:41 2007 From: jhaydon at snf.stanford.edu (jhaydon at snf.stanford.edu) Date: Mon, 29 Oct 2007 07:57:41 -0700 Subject: Comment wbgen2-hp SNF 2007-10-25 19:04:56: remove problem; hot pot is fine Message-ID: