From rshyam at snf.stanford.edu Wed Nov 4 06:20:20 2009 From: rshyam at snf.stanford.edu (rshyam at snf.stanford.edu) Date: Wed, 4 Nov 2009 06:20:20 -0800 Subject: Comment wbmetal SNF 2009-11-04 06:20:19: Found PRX bath half-empty Message-ID: From tomada at snf.stanford.edu Wed Nov 11 13:25:19 2009 From: tomada at snf.stanford.edu (tomada at snf.stanford.edu) Date: Wed, 11 Nov 2009 13:25:19 -0800 Subject: Comment wbmetal SNF 2009-11-11 13:25:18: PRS1000 bath pink looking?! Message-ID: From fried at snf.stanford.edu Sat Nov 14 14:09:07 2009 From: fried at snf.stanford.edu (fried at snf.stanford.edu) Date: Sat, 14 Nov 2009 14:09:07 -0800 Subject: Comment wbmetal SNF 2009-11-14 14:09:07: spin dryer not totally dry Message-ID: Spin dryer / rinser produced wafers with a few water droplets on the back sides. From kenney at snf.stanford.edu Mon Nov 16 10:48:44 2009 From: kenney at snf.stanford.edu (kenney at snf.stanford.edu) Date: Mon, 16 Nov 2009 10:48:44 -0800 Subject: Problem wbmetal SNF 2009-11-16 10:48:43: Bent cassette alignment pin Message-ID: One of the two alignment pins is bent on one of the cassettes. This prevents the cassette from being properly aligned with another cassette. This could cause some one to lose their wafers when performing a cassette-to-cassette transfer. I left ths damaged cassette on top of the blue boxes in the upper left hand corner of the bench. From uli at snf.stanford.edu Fri Nov 20 18:06:05 2009 From: uli at snf.stanford.edu (uli at snf.stanford.edu) Date: Fri, 20 Nov 2009 18:06:05 -0800 Subject: Comment wbmetal SNF 2009-11-11 13:25:18: PRS1000 bath pink looking?! Message-ID: cleaned From uli at snf.stanford.edu Fri Nov 20 18:06:25 2009 From: uli at snf.stanford.edu (uli at snf.stanford.edu) Date: Fri, 20 Nov 2009 18:06:25 -0800 Subject: Comment wbmetal SNF 2009-11-04 06:20:19: Found PRX bath half-empty Message-ID: filled up From pponce at snf.stanford.edu Sun Nov 22 14:40:47 2009 From: pponce at snf.stanford.edu (pponce at snf.stanford.edu) Date: Sun, 22 Nov 2009 14:40:47 -0800 Subject: Problem wbmetal SNF 2009-11-22 14:40:46: low exhaust Message-ID: The magnehelic gauge is low: reading is only 0.3 From jhaydon at snf.stanford.edu Mon Nov 23 14:36:55 2009 From: jhaydon at snf.stanford.edu (jhaydon at snf.stanford.edu) Date: Mon, 23 Nov 2009 14:36:55 -0800 Subject: Problem wbmetal SNF 2009-11-22 14:40:46: low exhaust Message-ID: their was some liquid in the the line going to the magnehelic gauge. Cleared line now reads 0.74 inches of water From uli at snf.stanford.edu Mon Nov 23 17:17:35 2009 From: uli at snf.stanford.edu (uli at snf.stanford.edu) Date: Mon, 23 Nov 2009 17:17:35 -0800 Subject: Problem wbmetal SNF 2009-11-16 10:48:43: Bent cassette alignment pin Message-ID: removed cassette