From latta at snf.stanford.edu Tue Jun 5 11:51:22 2012 From: latta at snf.stanford.edu (latta at snf.stanford.edu) Date: Tue, 5 Jun 2012 11:51:22 -0700 Subject: Problem woollam SNF 2012-06-05 11:51:22: Error during calibration Message-ID: Used cal sample and got the error insuffient intensity for z stage From fpurkl at snf.stanford.edu Tue Jun 5 14:53:40 2012 From: fpurkl at snf.stanford.edu (fpurkl at snf.stanford.edu) Date: Tue, 5 Jun 2012 14:53:40 -0700 Subject: Problem woollam SNF 2012-06-05 14:53:40: sample alignment failed Message-ID: similar error as nancy, intensity to low during sample alignment. From emyers at snf.stanford.edu Tue Jun 5 15:35:55 2012 From: emyers at snf.stanford.edu (emyers at snf.stanford.edu) Date: Tue, 5 Jun 2012 15:35:55 -0700 Subject: Problem woollam SNF 2012-06-05 11:51:22: Error during calibration Message-ID: Someone changed the default sample height for the system. The stage has been recalibrated From emyers at snf.stanford.edu Tue Jun 5 15:36:02 2012 From: emyers at snf.stanford.edu (emyers at snf.stanford.edu) Date: Tue, 5 Jun 2012 15:36:02 -0700 Subject: Problem woollam SNF 2012-06-05 14:53:40: sample alignment failed Message-ID: Someone changed the default sample height for the system. The stage has been recalibrated From fpurkl at snf.stanford.edu Tue Jun 26 10:28:32 2012 From: fpurkl at snf.stanford.edu (fpurkl at snf.stanford.edu) Date: Tue, 26 Jun 2012 10:28:32 -0700 Subject: Problem woollam SNF 2012-06-26 10:28:31: motors slip Message-ID: The motors sometimes slip (audible) when moving from high angles (>75) back to low angles (<75). The angle for any following measurement is wrong. Homing everything after this happens seems to reset the angle. From ross at snf.stanford.edu Wed Jun 27 20:11:13 2012 From: ross at snf.stanford.edu (ross at snf.stanford.edu) Date: Wed, 27 Jun 2012 20:11:13 -0700 Subject: Problem woollam SNF 2012-06-27 20:11:12: "Cannot home polarizer" error Message-ID: Window pops up with "cannot home polarizer" and will not run VASE manager programs. From jperez at snf.stanford.edu Fri Jun 29 11:26:32 2012 From: jperez at snf.stanford.edu (jperez at snf.stanford.edu) Date: Fri, 29 Jun 2012 11:26:32 -0700 Subject: Problem woollam SNF 2012-06-27 20:11:12: "Cannot home polarizer" error Message-ID: Homing just fine if enabled on Coral. From emyers at snf.stanford.edu Fri Jun 29 13:54:10 2012 From: emyers at snf.stanford.edu (emyers at snf.stanford.edu) Date: Fri, 29 Jun 2012 13:54:10 -0700 Subject: Problem woollam SNF 2012-06-26 10:28:31: motors slip Message-ID: I have not seen this and it seems to be working