From gsosa at snf.stanford.edu Sat Oct 1 12:13:22 2011 From: gsosa at snf.stanford.edu (gsosa at snf.stanford.edu) Date: Sat, 1 Oct 2011 12:13:22 -0700 Subject: Problem yes SNF 2011-09-30 17:52:32: failed at step 6 twice Message-ID: Door gasket sliding off of chanel at lower left corner of chamber. Replaced the door gasket and increased the tension on the gasket hold down clips. Tested with several cycles. All OK. From helencxy at snf.stanford.edu Mon Oct 3 19:51:11 2011 From: helencxy at snf.stanford.edu (helencxy at snf.stanford.edu) Date: Mon, 3 Oct 2011 19:51:11 -0700 Subject: Problem yes SNF 2011-10-03 19:51:11: Door can't open after the cycle is done Message-ID: Heard the finishing alarm and pressed RESET, then realized that the door can't be opened...Looked like the chamber was not entirely under atmosphere pressure. Had to re-start the cycle and stop at the end of step 3 to get my samples out. From vilanova at snf.stanford.edu Tue Oct 4 07:57:14 2011 From: vilanova at snf.stanford.edu (vilanova at snf.stanford.edu) Date: Tue, 4 Oct 2011 07:57:14 -0700 Subject: Problem yes SNF 2011-10-03 19:51:11: Door can't open after the cycle is done Message-ID: System Ok, MAybe Someone was trying to open the door while Before it Completed the Entire cycle, Ive notice People Use it After the Problem was Report it and I guess everything was Fine, I cycled It One more time just to make sure everything was Fine, And System Went through Without any problems, Operations are ok, Ready to use. From vilanova at snf.stanford.edu Wed Oct 5 08:28:19 2011 From: vilanova at snf.stanford.edu (vilanova at snf.stanford.edu) Date: Wed, 5 Oct 2011 08:28:19 -0700 Subject: Comment yes SNF 2011-10-05 08:28:18: Someone changed 1 of the Programs Steps!!!!!! Message-ID: please do not change any of the programs steps on the yes oven this morning during my daily rounds i found step 13 Om a different step setting this will ruins everyones wafers and this will also prevent users from opening the door ,!!! PLEASE DO NOT TOUCH OR CHANGE ANY OF THE SETTINGS!!! SPECIALLY IF YOU DONT KNOW WHAT YOUR DOING, IF THERES A PROBLEM WITH IT JUST REPORT IT ON CORAL AND MAINTENANCE WILL TAKE CARE OF IT AS SOON IS POSSIBLE, RE ENTERED ALL THE RIGHT SETTINGS AND TESTED, OK TO USE.